Installation of CNC plasma cutting machine

The CNC plasma cutting machine is equipment that uses plasma as a heat source for cutting. Pay attention to the following after purchasing the machine

1. Precautions for installation of CNC plasma cutting machine

2.CNC plasma cutting machine power supply

Precautions for installation of CNC plasma cutting machine

After unpacking, place the power supply of the CNC plasma cutting machine in the middle of the left side, under the plank, and place the control cabinet at the back of the left side of the CNC plasma cutting machine, so that the operator can visually observe the entire cutting machine and the cutting process. Remove the drag chain package on the left and place it parallel to the cutting machine. Use the level to level the equipment with the 6 anchor bolt adjustment seats provided with the machine.

Connect the power cord of the CNC plasma cutting machine to the power supply of the workshop with a power of 8KW. Connect the ground wire of the plasma power supply to the grid frame or steel plate of the workbench.

Connect the power cord of the control cabinet to the power supply of the workshop with a power of 3KW. Connect the plugs on the back of the computer to the control cabinet correspondingly. Install the monitor and connect the power and signal cables. Connect the inlet and outlet pipes, and drain the water to make the water depth in the sink reach 80mm. Connect the compressed air pipe to the inlet connector of the plasma power supply, and adjust the air pressure to 5.0.

Turn on the main power supply, control cabinet key switch, host power supply, display, and plasma power supply in turn. Operate according to the plasma power supply manual, system operation manual, and user manual, and do not modify the parameters that have been set in the system at will if you are not proficient.

If you find that the cutting quality is not good and cannot be solved, you should check the electrode and nozzle of the plasma cutting torch, and replace them if they are damaged.

CNC plasma cutting machine power supply

The CNC plasma cutting machine generally has two power cables: 1. The total power supply cable of the control system, the power is 2KW, and the voltage: three-phase 380V. 2. Plasma power supply cable, power 8.4KW, voltage: three-phase 380V. To

The length of the external cable from the equipment is about 15m, the total power supply cable of the control system is a 3+1 cable with a wire diameter of 2mm2, and the plasma power supply cable is a 4-core cable with a wire diameter of 6mm2. The two cables and air pipes slide in a ring shape through the aerial tow frame, and descend along the factory wall to the main power switch cabinet to enter, and connect them to the lower ends of different switches. Both the control system and the plasma power supply must be reliably grounded. To

To avoid the influence of large power fluctuations and possible instantaneous interference signals, the CNC plasma cutting machine should adopt a dedicated line power supply or add voltage stabilizing devices to reduce the impact of power supply quality and electrical interference. To

If there are a large number of high-frequency interference sources such as electric welding machines, argon arc welding machines, plasma cutting machines, and high-power inverters in the equipment workplace, please install a filter on the power supply cable for the CNC system to shield the interference. To

Sudden power failure will result in the loss of cutting files and produce waste; frequent sudden power failure will cause damage to the CNC system software and even hardware. Therefore, for occasions with frequent power failures, a 500W UPS power supply should be considered for the CNC plasma cutting machine.

Shandong U-May CNC Technology Co., Ltd. constantly maintains a cutting-edge perspective in product technology and keeps pace with the times. At the same time, based on the awe of the market and the understanding of users, we will continue to deepen the emphasis on user experience, take the achievement of customer goals as our own responsibility, and use professional strength to make production worry-free and strive to achieve the perfection of product services and customer goals. Combine.